03/31/14
Passport 1000 P2 WiFi Exit Device
15 1-800-810-WIRE • www.sargentlock.com • A8012F
Fig. 14
13 Install Battery Pack
14 Install Inside Escutcheon
Inside of Door
Fig. 13
For battery replacement:
When replacing the (6) “AA” alkaline batteries in the compartment,
please note batteries must be replaced within five (5) minutes to
prevent the internal clock from becoming inaccurate.
1. Position inside escutcheon as shown (Fig. 14).
Verify that all wires are positioned within the escutcheon
to avoid pinching.
2. Attach escutcheon with (2) #8-32 x 1/2” T-20 Torx pan
head screws.
3. Straighten escutcheon and tighten securely.
DO NOT OVERTIGHTEN.
(2) #8-32 x 1/2”
Torx Screws
a. Place (6) “AA” alkaline batteries in the compartment, being
careful to align polarity properly.
b. After batteries are installed, there is a slight delay; then the LED
will flash amber and the lock motor will cycle.
Before installing batteries for the first time:
Remove
pull tab
from its position beneath the coin cell by pulling
on tab in direction of arrows printed on tab (Fig. 13).
