1-800-810-WIRE • www.sargentlock.com • A8205B 10
Copyright © 2018, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
01/31/18
IN220 Exit Device
Installation Wiring (Continued)
Components and wire harness supplied by McKinney. Suggested installation:
RJ45-M
Molex-M
Cable
: Cat 5e or higher
24 A
WG , 100ohm
B-Splice
Crimp Connector
Ceiling
Supplied by CI
Cut end / ceiling-side PoE harness:
TIA/EIA 568-B Standard Wiring
1
2 3
4 5 6
7
8
Do not confuse pair numbers with pin numbers. A pair number is
used for reference only (eg: 10BaseT Ethernet uses pairs 2 & 3). The
pin numbers indicate actual physical locations on the plug and jack.
Frame-Side
Harness
Assembly
(15' length)
24AWG
Stranded
Drain
Wire for
Earth
Ground in
15' Frame
Harness
Cable
drain wire
concealed in
shrink tubing
Frame Harness Installation
1. Feed cut end of harness into hole on hinge-side through single access hole.
2. Push one connector back through the hole and feed into the other access hole.
Each of the hinge-side harness connectors should end up threaded through
a different access hole and matched to the same size pin connector from
the door harness:
• 4-pin male molex connector.
• 6-pin male molex connector with ground wire.
Hinge side of PoE harness:
A
PIN
Wire
Pair
Number
1
White/Orange
2
2
Orange
2
3
White/Green
3
4
Blue
1
5
White/Blue
1
6
Green
3
7
White/Brown
4
8
Brown
4
1
8
pin
8
1
pin
4-pin M
6-pin M
Frame
PoE Hinge
PoE Data Hinge
Hinge-side harness connectors:
• 4-pin female molex connector
• 6-pin female molex connector with ground wire
Lock-side harness connectors:
• 4-pin female molex connector
• 6-pin female molex connector with ground wire
B
4-pin F
6-pin F
4-pin F
6-pin F
Summary of Contents for Sargent IN220
Page 2: ......
