01/31/18
13 1-800-810-WIRE • www.sargentlock.com • A8205B
Copyright © 2018, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
IN220 Exit Device
Wood doors have 3/8” raceway to controller cutout and metal doors
have 3/4” raceway to the controller cutout.
Refer to template A8214.
1. Insert connector end of DPS through the raceway on the latch edge of
the door (Fig. 2A).
Note: For metal doors, use DPS Collar.
2. Push DPS firmly into place by hand.
IMPORTANT
: DO NOT TAP SWITCH WITH ANY TOOL.
Wood Frame
Metal Frame
Dim 1
3/8”
3/4”
Horizontal
of Strike
Door Position
Switch Hole
Vertical
of Strike
Dim 2
(From template)
Dim 1
Fig. 2B
DPS
(Door Position
Switch)
Collar is used only
with metal doors
Door Frame
DPS
(Door Position
Switch)
2 Install Door Position Switch (DPS)
Summary of Contents for Sargent IN220
Page 2: ......
