10 1-800-810-WIRE • www.sargentlock.com • A7856C
Profile Series v.G1.5 Rim Exit Device
Copyright © 2016, Sargent Manufacturing Company
, an ASSA ABLOY Group company
. All rights reser
ved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
10/31/16
Step #3 – Mount Exit Device Chassis (Inside Trim)
1. Route ET harness along track cutout for wood doors and
through access hole for metal doors.
2. Position exit chassis carefully.
Do not pinch the wire harness.
3. Engage ET spindle in hub of exit device chassis.
4. Secure the exit chassis with through-bolts
to the ET trim using (2) 1/4 -20 x 2-3/8”
flat head machine screws.
Correct Incorrect
Fig. 4C
Step #4 – Install Cylinder and Secure Chassis
For devices without cylinder, skip this step.
1. Insert cylinder into ET control (Fig. 4A).
2. Mate cylinder tailpiece into hub of exit device chassis.
3. Make sure ET harness is clear of cylinder and cylinder tailpiece.
4. Secure cylinder to exit chassis using (2) #12-24 x 1-7/8”
connecting screws (Fig 4B).
5. Fasten exit chassis to door using:
• (4) #10 wood screws for wood doors (or)
• (4) #10-24 machine screws for metal doors.
6. Position cylinder so that the SARGENT
logo is right-side up (Fig. 4C).
Inside of Door
Fig. 3
(2) 1/4 x 2-3/8” Flathead
Machine Screws
Exit Chassis
ET Motor
Harness
(4) #10 Wood or
#10-24 Machine
Screws
(2) #12-24 x 1-7/8”
Flat Head Screws
(Connecting Cylinder)
Inside of Door
Outside of Door
Inside of Door
Fig. 4B
Fig. 4A
Fig. 4B
Summary of Contents for v.G1.5
Page 2: ......
