Sargent v.G1.5, Installation Instructions Manual

10/31/16

1-800-810-WIRE • www.sargentlock.com • A7856C         23

Copyright © 2016, Sargen

t Manufacturing Company

, an A

SS

A AB

LO

Y G

roup company

. All right

s reser

ved

. 

Reproductions in whole or in par

t without express writ

ten permission of Sargen

t Manufacturing Company is prohibited

.

Profile Series v.G1.5/LK Exit Device    

Before the controller is attached to the door (Fig. 1A):

1.  Attach the reader cable to the controller. 
2.  Attach the connector from the lock into the bottom  

of the circuit board (TB2, Fig. 3B). 

3.  Plug the ground wire into the bottom of the controller assembly (E1, Fig. 3B).
4.  Route the connector from the raceway through the top opening between the controller and the escutch-

eon, along the battery keeper, back under the bottom opening between the controller and escutcheon and 

attach at the bottom of the controller. 

Note: Connectors go on only one way. 
Do not offset connectors and make sure they are completely seated.

A

A

B

C

D

Fig.  1

ElectroLynx Lock Wire Connections 

Door Position Switch (DPS) 

Install the SARGENT 3287 Door Status Switch according to 

instructions included in the kit. 
Wire the 3287 Door Status Switch to the ElectroLynx frame har-

ness and to the door status wires:

1.  Connect the common wire of the switch to the common wire 

of the harness.

2.  Connect the normally open wire of the switch to the door 

position wire of the harness.

Note: The third wire (normally closed) of the 3287 Door     

Status Switch is not used for this type of system. 

Inside 

Escutcheon  

(Back)

Inside of Door

1

1

2

3

4

4

4

2

Inside 

Escutcheon  

(Front)

Fig.  1A