1-800-810-WIRE • www.sargentlock.com • A7856C 9
Profile Series v.G1.5 Rim Exit Device
Copyright © 2016, Sargent Manufacturing Company
, an ASSA ABLOY Group company
. All rights reser
ved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
10/31/16
For exterior applications, use ET gasket (P/N 52-0263)
to seal between ET escutcheon and outside door surface.
1A. For wood doors: Route ET wire harness through the cylinder
hole, out the other side, and through the wire run channel to
the controller cutout.
1B. For metal doors: Route ET wire harness
through the cylinder hole and door
and out the controller cutout.
2. Position and hold ET trim on the door.
3. Connector from ET harness connects
to connector from chassis (Fig. 2)
6
Installation Instructions: 8877/8878 Rim Type Exit Device
Step #2 – Position Exit Trim (ET)
Step #1 – Prepare Door
A. Verify Hand and Bevel of Door
• This device is non-handed.
• Door should be fitted and hung.
• Verify box label for size of exit device and function.
Inside
Outside
Left Hand
Reverse Bevel
LHRB
Right Hand
Reverse Bevel
RHRB
Fig. 1
B. Door Preparation
If using a mullion, install prior to installing hardware.
Doors should be pre-prepped.
Prepare door according to appropriate template:
• Exit installation instructions A6770
• Door Manufacturer’s Template 4640 (Metal and Wood)
Note: Wood door has additional cutout if installation includes a cylinder.
Outside of Door
ET Wire Harness
(from motor)
Fig. 2
Exit trim
Exit trim Gasket
(Exterior Applications)
Summary of Contents for v.G1.5
Page 2: ......
