6
Stand V11/2017 O/IH/SA V12 10/2018 TM
UK
CLEANING, CARE & MAINTENANCE
1 Switch off and disconnect from the power supply before cleaning
2 The doors can be removed for ease of cleaning
3 Clean the interior of the appliance as often as possible
4 Do not use abrasive cleaning agents These can leave harmful residues
5 Clean the door seal with water only
6 Always wipe dry after cleaning
7 Do not allow water used in cleaning to run through the drain hole into the evaporation pan
REPLACING THE INTERIOR LAMP
Call your dealer or a qualified electrician, the Lamp Assembly is available to purchase as a spare part
CLEANING THE CONDENSER
Periodic cleaning of the Condenser can extend the life of the appliance, recommend that a agent
TROUBLE SHOOTING
If your appliance develops a fault, please check the following table before making a call to the helpline
FAULT
PROBABLE CAUSE
ACTION REQUIRED
The appliance is not working
The unit is not switched on
Check the unit is plugged in correctly and
switched on
Plug and lead are damaged
Call or qualified technician
Fuse in the plug has blown
Replace the fuse
Power supply
Check power supply
Internal wiring fault
Call or qualified technician
The appliance turns on, but
the temperature is too high/
low
Too much ice on the condenser
Defrost the appliance
Condenser blocked with dust
Call or qualified technician
Doors are not shut properly
Check doors are shut and seals are not
damaged
Appliance is located near a heat source,
in the direct sunlight or air flow to the
condenser is being interrupted
Move the refrigerator to a more suitable
location
Ambient temperature is too high
Increase ventilation or move appliance to a
cooler position
Unsuitable foodstuffs are being stored in
the appliance
Remove any excessive hot foodstuffs or
blockages to fan
Appliance is overloaded
Reduce the amount of food stored in the
appliance
Factory default parameters adjusted
Call or qualified technician
The appliance is leaking
water
The appliance is not properly
levelled
Adjust the screw feet to level the appliance
(if applicable)
The appliance is unusually
loud
Loose screw/nut
Check and tighten all nuts and screws
The appliance has not been
installed in a level or stable
position
Check installation position and change
if necessary
The display lamp does not
illuminate
Lamp needs replacing
Call or qualified technician
Light not turned On
Ensure Light button has been pressed
properly
Door does not shut
Dirt/obstacle in runners
Clean runners
