User Manual
.
Version 1.2
25
Appendix 1
RX/TX Pairing
“Pairing” is performed to establish/re-establish a connection between the RX and
TX. These procedures are used during troubleshooting (i.e. video fails to appear on
TV) or when installing an additional RX to the environment. There are two ways to
Pair the RX and TX as described below:
a) “Pairing” using the buttons on the RX and TX rear Panels:
1. Press the Group button on the rear panel of the RX until the “PAIRING”
message displays on the TV attached to the RX.
2. Press the Group button on the rear panel of the TX for 2 seconds.
If the link is successful, the message on the TV screen will change from
“PAIRING” to “PAIRED”, followed by the video (if video is currently streaming
from the source).
b) “Pairing” using the remote controller
Push the
(Group Button) on the remote controller to pair the RX and TX.
NOTE:
It is strongly recommended to do these procedures (Pairing) with the RX
and TX in the same vicinity, preferably on the same power outlet (for testing). Also
see “Troubleshooting” section and “Adding a new RX” section for proper use of
these procedures.
