“EC Verification” –
A Service Offered by Sartorius
Our service technicians authorized to perform
the verification* of your balances/scales which are
acceptable for legal metrological verification can
inspect and verify the metrological specifications on-
site within the member states of the European Union.
“New Installation” Service
Initial verification is covered in our “New Installation”
service package. In addition to initial verification, this
package provides you with a series of important
services which will guarantee you optimal results in
working with your balance/scale:
– Installation
– Training
– Startup
– Initial verification
– Inspection
If you would like Sartorius to perform initial
verification of your balance/scale, please contact
your local Sartorius office, dealer or service center.
Please refer to the Sartorius Service Center
Addresses on page 7–4.
Preparing the Balance/Scale for Initial Verification
– Unpack the balance/scale.
– Plug the cord of the AC adapter into the power
receptacle on the balance/scale, and plug the AC
adapter into a wall outlet.
–
Let the balance/scale warm up for at least 24 hours
after initially connecting it to AC power (or after
a relatively long power failure or outage).
Subsequent Verifications within the European Union
The validity of the verification will become void in
accordance with the national regulations of the country
in which the balance/scale is used.
For information on verification and legal regulations
currently applicable in your country, and to obtain the
names of the persons to contact, please contact your
local Sartorius office, dealer or service center as
indicated on the following page.
* = pursuant to accreditation for Sartorius AG
7–4
