Getting Started
Preparing the AC Series Balance
In the following order, install the draft shield base
plate
(4)
, the shield plate
(3)
, the protective ring
(2)
and the weighing pan
(1)
one at a time in the
weighing chamber.
Preparing the LC Series Balance
with a Round Glass Draft Shield
Place the draft shield base plate
(4)
on the balance.
Turn the plate clockwise until it snaps into place
(this procedure is necessary for preparing the balance
for operation with or without a dust cover).
Mount the pan support disk
(26)
, the weighing
pan
(1)
, the glass draft shield cylinder
(25)
and the
draft shield lid
(24)
one at a time on the balance.
Preparing the LC Series Balance
with a Round Weighing Pan/GC 1201-G
Place the centering disk
(27)
on the balance.
Turn the disk clockwise until it snaps into place (this
procedure is necessary for preparing the balance
for operation with or without a dust cover).
Then mount the pan support disk
(26)
and the
weighing pan
(1)
one at a time on the balance
in the order given.
Important Note Concerning All Verified Balances
Approved for Use as Legal Measuring Instruments
in the EU
Provided that an official seal is required for
the verified balance, a control seal is affixed to
the balance. Unauthorized attempts to remove this
seal will irreversibly damage it. If you break
the seal, the validity of the verification will become
void, and you must have your balance re-verified.
1–9
