Entris
®
II Advanced Line Operating Instructions
45
Decommissioning
11 Decommissioning
11 .1 Decommissioning the Device
Procedure
t
Turn the device off .
t
Disconnect the device from the power supply .
t
Disconnect the device from all connected devices
and all accessories, e .g . printer .
t
Clean the device (see Chapter 9.2, page 41).
12 Storage and Shipping
12 .1 Storage
Procedure
t
Turn the device off .
t
Disconnect the device from the power supply .
t
Disconnect the device from all connected devices,
e .g . printer .
t
Store the device according to the ambient conditions
12 .2 Returning the Device and Parts
Defective devices or parts can be sent back to Sartorius .
Returned devices must be clean, decontaminated, and
properly packed .
Transport damage as well as measures for subsequent
cleaning and disinfection of the device or parts by
Sartorius shall be charged to sender .
Devices contaminated with hazardous materials, e .g .
harmful biological or chemical substances, will
not
be
accepted for repair or disposal . The devices must be
decontaminated before shipping (for decontamination,
see Chapter “13 .1 Decontaminating the Device”,
page 45) .
Procedure
t
Turn the device off .
t
Disconnect the device from the power supply .
t
Contact Sartorius Service for instructions on how to
return devices or parts (please refer to
www .sartorius .com) .
t
Pack the device and its parts properly for return, e .g .
in their original packaging .
13 Disposal
13 .1 Decontaminating the Device
The device does
not
contain any hazardous materials
that necessitate special disposal measures . If the device
has come into contact with hazardous substances: Steps
must be taken to ensure proper decontamination and
declaration .
Procedure
t
If the device has come into contact with hazardous
substances: Decontaminate the device . The operator
of the device is responsible for adhering to local
government regulations on the proper
decontamination and declaration for transport and
disposal .
13 .2 Disposing of Device and Parts
The device and the device accessories must be disposed
of properly by disposal facilities .
A lithium cell battery, type CR2032, is installed inside
the device . Batteries must be disposed of properly by
disposal facilities .
The packaging is made of environmentally friendly
materials that can be used as secondary raw materials .
Requirements
The device has been decontaminated .
Procedure
t
Dispose of the device . Follow the disposal
instructions on our website (www .sartorius .com) .
t
Inform the disposal facility that there is a lithium cell
battery, type CR2032, installed inside the device .
t
Dispose of the packaging in accordance with local
government regulations .
Summary of Contents for Entris II Advanced BCA124-1S
Page 324: ......
