93
Individual Identification Codes (ID)
Purpose
With this function you can assign
identifiers to values for documentation
and printouts.
You can use this extra function
in combination with a program from
Application 1 (e.g., counting, weighing
in percent), one from Application 2
(checkweighing, time-controlled func-
tions) and one from Application 3
(totalizing, formulation, statistics) as
well as with the other extra functions.
Available Features
– Store up to 4 IDs; these can be stored,
changed or deleted individually.
– Each ID consists of a name and a value;
both can be defined by the user.
– ID designations are configured in the
Setup: Input menu.
– Each ID designation can have up to
20 characters; when you enter the value
later, however, no more than 15 charac-
ters of the designation are displayed.
– The ID values are entered while the
application program is active; press the
ID
soft key to toggle to the ID input
mode.
– Each ID value can have up to
20 characters.
– Access 1 of the 4 IDs directly using the
numeric keys. The other three can only
be accessed by pressing the
ID
soft key
to toggle to the identifier input mode.
– You can assign this function to the
fourth or fifth soft key (from the right),
i.e. F4 or F5.
– You can configure when the ID is
included on the printout
(see “Preparation,” next page).
– You can configure the position of IDs
on the individual or total printout.
– The designation is printed flush left;
the value flush right. If the name and
value together are too long for one line,
the data is printed on two lines.
– Optional configuration in the Setup
menu to delete a single character when
entering an identifier by pressing
c
.
Setup: Device: Keys: CF function for
input: Delete last character
– Press the
Delete
soft key to delete
an ID
Factory Settings for ID Designations
ID1:
ID1
ID2:
ID2
ID3:
ID3
ID4:
ID4
Factory Settings for ID Values
No values set
Factory Settings for Other Parameters
Printout:
Each time the print key
is pressed
Soft Key Functions
ID
Toggle to “Identification
codes” menu
Delete
Delete input of selected ID
