Entering User Data (Input)
Purpose
To display, input or change user data.
You can block access to these data by
assigning a password.
Features
You can display, input or change the
following user data:
– Workstation number* for the balance:
ID (balance ID; max. 20 characters)**
– Weighing series number, to designate
a series or lot:
L ID (lot ID; max. 20 characters)**
– Weight set number for calibration/
adjustment: W ID (weight ID;
max. 14 characters)**
– Exact weight value for calibra-
tion/adjustment of the balance (see
the section on “Calibration and Adjust-
ment,” in the chapter entitled
“Operation.”
– Password for access to the Setup menu:
Input and Setup:
Menu (max. 8 characters)**
*
**
Only in conjunction with ISO/GLP-com-
pliant printouts (see the section
on “Setting Parameters” in the chapter
entitled “Configuration” under menu
code number 8 10 x).
** A decimal point is displayed together
with its preceding digit or character;
it does, however, count as a separate
character. This also applies when you
enter S ID and NUM as well as to data
entered via the interface.
*** To delete user password:
Enter a decimal point using the
.
key
and confirm
Factory Settings
Password: No designation
If no password has been assigned, any-
one can access the “Setup: Input” and
“Setup: Menu” functions without enter-
ing a password.
If you assign a password and then for-
get what the word is, you can use the
General Password (see Appendix) to
access these menus.
Preparation
Display existing user data
G
Select the Setup program: Press
M
> The soft keys
Info
,
Menu
and
Input
are displayed in the text line
G
Select the user data input function:
Press the
Input
softkey
v
> The password prompt is displayed
k
If access is blocked by a password:
enter the password using the alphanu-
meric input keys
G
Display user data:
Press the
enter passw.
soft key
v
> The last 8 digits of a workstation/
balance number (ID no.), if any ID is
assigned, are displayed in the measured
value line
Enter/Change Password
G
Select the Setup menu:
Press
M
> The soft keys
Info
,
Menu
and
Input
are displayed in the text line
G
Select the user data input function:
Press the
Input
soft key
v
If you have already assigned
a password:
> The password prompt is displayed
k
Enter the password
k
Press the
enter passw.
soft key
v
G
Write down the password here:
Password = ........................................
If you no longer remember the pass-
word assigned:
k
Enter the General Password
(see Appendix)
k
Press the
enter passw.
soft key
v
> The last 8 digits of a workstation/
balance number (ID no.), if any ID is
assigned, are displayed in the measured
value line
G
Select password setting:
Press
y
>
Password
is displayed
in the text line
> If a password exists, it is now displayed
in the measured value line
G
New password: Enter the letters/
numbers for the new password
(8 characters max.)**
The password “none” means that no
password is stored.***
G
Confirm input: Press
X
G
Exit the Setup menu:
Press
M
> Restart the application
14
