39
System Settings (Setup Menu)
User Manual Secura
®
, Quintix
®
, Practum
®
6.2.11 More Settings
More settings
Set password
Reset settings
USB mass storage
Enable service mode
Additional service functions for the balance can be found here .
Set password
menu option (Secura
®
only):
Secura
®
models can be password-protected to prevent unauthorized personnel from
making changes to the system settings of the balance .
When a user password is set, all settings which could change the metrological
behavior of the balance are locked .
t
Select
t
.
t
Enter a number as a password .
To make corrections to the entry:
–
k
button: delete individual characters .
–
C
button: delete all characters .
t
Enter the password again to ensure correct entry .
t
Confirm with
l
.
t
The new password will only be applied after returning to the first level of the
menu .
To change the password, the old password must first be entered .
A new password can then be set .
To completely delete the password and use the balance without password protection,
leave the entry blank .
Contact the Sartorius Service Center if you forget the password .
Reset settings
menu option:
Reset all balance settings to the factory (default) settings here .
t
When the prompt appears, select
Yes, reset
and confirm with
l
. The balance is
reset and restarts .
USB mass storage
menu option:
Use this function to register the balance memory as a USB removable data carrier on
a PC . This function is required by the Sartorius Service Center or when installing the
PC driver for the virtual COM port . Further information can be found in Chapter “USB
Port” on page 79 .
Enable service mode
menu option:
This function is used by the Sartorius Service Center and can only be accessed by
authorized Service Center personnel . The following service functions are available:
– Preset value for minimum weighing (SQmin)
– Enter date for next service
– Reset all settings to factory settings
The
Calibration/Adjustment
menu also provides the following functions for
authorized Service personnel (depending on the model):
– External linearization (not for use in legal metrology)
– Set the preload
– Delete the preload
These functions are not available for verified and sealed balances .
Summary of Contents for Practum
