12
Operating Instructions YDP30 | YDP30-NET
Getting Started
5.4
Switching the Device On or Off
Procedure
t
To switch the device on: Press the On/Off switch so that it is
in the “I” position .
y
When the device is connected to a network: The device
establishes a connection to the Wi-Fi network or corporate
network and retrieves an IP address for the device . This
procedure usually takes 20 seconds .
y
The LED display illuminates in the color “yellow” .
y
If media and an ink ribbon are inserted into the device: The
device will print an initial printout containing the Sartorius
logo and the current software version .
y
The LED display illuminates in the color “green” . The device
is ready for use .
t
To switch the device off: Press the On/Off switch so that it
is in the “O” position .
5.5
Opening or Closing the Top Cover
Requirements
The device is switched off .
Procedure
t
To open the top cover:
t
Pull the levers located
on both sides of the top
cover forwards .
t
Open the top cover upward and push it backward until
it stops .
y
The top cover lock audibly engages .
t
To close the top cover:
t
Push sideways against top cover lock . This will unlock
the top cover .
t
Push the top cover back down . Both levers should snap
into place .
5.6
Inserting Media into the Device
5.6.1
Inserting Media into the Media Mount
The media spool, e .g . the standard paper roll, must be inserted
between the 2 media mounts . The print side of the media must
be facing up .
Requirements
− The print roller is clean (see Chapter “7 .2 Maintenance
− The device is switched off .
Procedure
t
Check if the media are suitable for the device (suitability,
see Chapter “13 .7 Ink Ribbon”, page 25) .
t
Open the top cover .
t
Check if the media mount is
set to the right media spool
size .
t
If required: Push the
2 mounts apart and turn
them 180° .
t
Push the 2 mounts apart and fix the media spool between
the mounts .
t
Push the media over the
media feed, the sensor for
black marking and the print
roller .
t
Turn the setting wheel for the media feed so that the media
feed is set to the width of the inserted media .
t
Close the top cover .
