7. Use caution when cleaning the face piece lens. Although the outer surface of the lens has a
proprietary anti-scratch coating, it can be damaged through careless or abusive handling. Do not
attempt to "polish out" scratches with any abrasive agent as this will only cause further damage to
the remaining coating. Warm, soapy water (using Joy, Mr. Clean, Lestoil, etc.) is usually adequate
to remove adhering grime. Stubborn deposits may require the use of denatured or isopropyl
alcohol or other mild solvents. DO NOT allow any solvent to come into contact with rubber or
plastic parts. Use solvents only in a well-ventilated area.
REPAIR:
Repair of the Supplied Air Respirator by the user is limited to replacement of the components as listed on
the MSHA/NIOSH approval label. Disassembly should be performed only to the extent necessary to
replace the components.
WARNING
Before disassembly, make sure that all air is bled from the lines. Shut off or deplete the air supply to
prevent equipment damage or personal injury.
To protect your warranty and the MSHA/NIOSH certification on the equipment, all other repairs must be
done only by authorized Service Center. If there are none at your facility, consult your SURVIVAIR
distributor for the one nearest you.
STORAGE:
After inspection, cleaning and necessary repair, the Supplied-Air Respirator should be stored to
protect it against dust, sunlight, heat, extreme cold, excessive moisture, or damaging chemicals.
The Supplied Air Respirator should be stored in compartments built for that purpose. The
compartments should be clearly marked.
Spectacle Kit
P/N 7622-60
FOR USE WITH OPTI-FIT MASKS
INSTALLATION INSTRUCTIONS
1. TAKE FRAMES AND TEMPLE BARS TO AN OPTICIAN
FOR INSTALLATION OF PRESCRIPTION LENSES. (YOU
WILL NEED YOUR PRESCRIPTION) FRAMES USE 48mm
SIZE LENS ONLY.
2. INSERT SPECTACLE TEMPLE BARS INTO HOLES IN
TABS ON INSIDE OF MASK SKIRT.
3. POSITION SPECTACLES AS DESIRED.
16
Summary of Contents for Opti-Fit 9800-25
Page 15: ...11...
