15
Front side description – LED indicators and the button
For easier use and understanding, the device has an LED indicator on the front side. The description of the indicators is
described below.
When there is communication
going on between the control
centre and the thermostat, the
indicator on which the thermostat
is connected – blinks twice. Here
is also the indication for
connection of the thermostats.
When the heat
source or the
manifold pump is
activated, this LED
indicator turns on
(red)*.
When there is a need for
heating, the indicator under the
particular number (1-8) turns on
(green).
If the device is
turned on or
plugged in to
power supply, the
LED indicator
turns red.
* If there is no output on the exit 1-8 and are turned off, the next output on the heating source, pump, starts with a delay
of 3-5 minutes.
Button
-
With this button you can connect thermostats to the control centre. You can do that by holding this
button for 3 seconds.
You can also reset all the thermostat connections to the control centre. You have to turn unplug the control centre out
of the power supply and while plugging it back to the power supply, hold the button
and all the LED indicators
should blink three times.
