中文
EN
DE RU KO PT JA ES
02003
21
5.3 Warning Tone Setting
In working status, simultaneously press and hold "
▲
"
和
"
▼
" keys for about 3 seconds: "ON" indicates that the warning
tone is turned on, and "OFF" indicates that the warning tone is turned off.
5.4 Viewing Current Set Temperature
When the station is working, press the "
＊
" to show the currently set operating temperature on the window. If the "
＊
"
key is pressed again, the display will enter the "Temperature Point Setting" window
（
see 5.2
）
.
6. Parameter Settings
The default password of the soldering station is "000" , and temperature setting of soldering station is available under this
state. To limit the permission for temperature adjustment, change the password.
6.1 Enter Correct Password
6.1.1 Enter Parameter Setting Mode
1
）
Turn off the power switch, simultaneously press the "
▲
" and "
▼
" keys and then turn on the power switch.
2
）
Press and hold the"
▲
" and "
▼
" keys until the window displays
, indicating that you have entered the
parameter setting mode.
6.1.2 Enter Default Password
1
）
After entering the parameter setting mode, the window will display
, the leftmost hundreds digit will be
lighted, indicating that the password can be adjusted
（
namely you can enter the default password
）
.
2
）
Enter the default password:
Press the "
▲
" or "
▼
" key to select the hundreds digit, and press the "
＊
" key after
selecting, and then the tens digit will be lighted for you to set. The method for selecting the tens digit and units digit
is the same as that for selecting the hundreds digit. Press the "
＊
" key after selecting the units digit.
3
）
If you enter a wrong password for the first time:
the window will directly enter the password entering interface
for you to enter the password for the second time. The method is the same as that for first entry. Note: You have
two chances to enter a password. If you enter a wrong password for the first time, the window will directly enter the
password entering interface for you to enter the password for the second time.
4
）
If you enter a wrong password twice:
the window will return to the working state.
5
）
If you enter the correct password for the first time or the second time:
the window will directly enter the parameter
setting mode and displays the currently set working mode.
Note: If a wrong password is entered, it is unable to enter the mode of the parameter settings
（
including working mode
setting and password setting
）
.
