Operating Instructions SATAjet 3000 K spray mix
2. Functional Description
The paint spray gun SATAjet 3000 K spray mix has been designed for the application of stains, glazes
and paints as well as other liquid media in combination with airless pumps up to a spray viscosity
which can be still displayed in the DIN 4 cup (the nozzle size is depending on the spray viscosity).
Abrasive materials and materials containing acid or gasoline may not be applied with this spray gun.
The required air pressure is supplied at the air connection in the spray gun handle. The air valve
opens (pre-air control) when pulling the trigger to the first pressure point. Pulling the trigger further
pulls out the paint needle from the paint nozzle. Under pressure, the material flows out of the paint
nozzle and is atomised by the compressed air which comes out of the air cap at the same time.
IX.2
3. Construction
1 Paint nozzle (not within the scope of delivery)
2 Self tensioning needle packing (not visible)
3 Trigger
4 Self tensioning air piston packing (not visible)
5 Stepless regulation for round and flat spray
6 Air connection G ¼ outside
7 Air piston (not visible)
8 Air micrometer
9 Material pick-up tube with integrated material filter
10 Trigger block
11 Locking screw
1.2 Technical Data
•
Air connection
G 1/4
•
Material connection
G 1/4
•
Max. operating pressure air
10 bar/145 psi (1 MPa)
•
Max. operating temperature material 50 ° C
•
Max. operating pressure material
250 bar/3626 psi
Air consumption round and flat air cap
•
Flat fan 120 Nl/min/4.2 cfm at 3 bar/43.5 psi
•
Round fan 310 Nl/min/10.9 cfm at 3 bar/43.5 psi
Further product range and accessories
•
Filter system SATA filter 400
•
Respirators (half masks and full face respirators)
•
Material pump 14:1
•
Material pump 32:1
•
Strainer 60 msh, 100 msh und 200 msh
