Operating Instructions SATAjet 3000 K spray mix
b) Spray gun equipped with compressed air control gauge
Adjust the pressure at the pressure regulator in a way that the spray gun
inlet pressure required for the respective gun model is obtained.
Art. No. 4002
c) Spray gun without gauge
In order to make a correct adjustment of the spray gun inlet pressure, as
otherwise measureable in a) to b), without a gauge, adjust a pressure of
about 9 psi higher per 10 m to inlet pressure to compensate the pressure
drop in the hose.
a) Spray gun with micrometer / gauge
Ensure sufficient pressure by means of the pressure regulator. Adjust the
recommended inlet pressure of 1,5 - 2,0 bar/22 - 29 psi at the micrometer.
Art. No. 27771
4.4 Correct adjustment of the dynamic inlet pressure
Illustration similar
Illustration similar
Note:
- Micrometer in vertical position (position III - parallel to the gun body) =
maximum atomization and maximum internal spray gun pressure (identical
with spray gun inlet pressure)
- Position I or II (across gun body) = minimum atomization, minimum internal
spray gun pressure (for spot repair, speckling etc.)
Attention:
While the spray gun is connected to the air supply, the air micro-
meter fixing screw, pos. 11, must not be removed. When the fixing screw is
removed, the spray gun must not be put into operation.
!
Illustration similar
IX.4
