Operating Instructions SATAjet 3000 K spray mix
8. Cleaning and maintenace
Never use force. Using improper tools such as pliers, etc. will void any warranty. In many
cases proper repairs can only be carried out with the aid of special tools. In such cases,
limit yourself to establishing the cause of the problem and leave the repairs to the service depart-
ment. We refuse to accept liability for perfect functioning of the spray gun if it is disassembled by
the customer.
a)
Flush out the gun thoroughly with thinner or cleaning fluid.
b)
Clean the air nozzle with a paint brush or brush. Do not immerse the nozzle in thinner
or cleaning fluid.
c)
Under no circumstances try to clean clogged drillings using an unsuitable tool, since
the slightest amount of damage adversely affects the spray pattern.
Use SATA nozzle cleaning needles ((included in cleaning kit 64030).
d)
Only remove the black air distribution ring (Art. No. 97824 / set of 3) in the gun
head in case it is damaged (no sealing performance at the paint nozzle).
Following removal, always insert a new air distribution ring to ensure flawless function.
Insert new air distribution ring in its correct position and tighten paint nozzle again.
Respect mounting instructions for the air distribution ring (see 6.1)!
e)
Slightly oil movable parts with SATA special grease (Art. No. 10009).
IX.6
A mounting instruction of the air distribution ring can be found as a PDF and as a
video on our homepage www.sata.com/Media. Also more information on spray gun
cleaning can be obtained from a video.
Important Notice:
Gun may be cleaned with solvent or cleaning agents manually or in a conventional gun
washing machine.
The following actions damage the gun/system, may lead to the loss of the
explosion-proofness approval and entirely annull any warranty claims:
- Immersing the gun in solvent or cleaning agents, or for a period longer than required for
the cleaning process as such
- Storing the gun inside the gun washing machine
- Cleaning the gun by means of ultrasound cleaning systems
- Exerting violent, inappropriate treatment
Should the material connection 98608 in the spray gun body loosen when removing
the material tube 98590, respectively, please proceed as follows:
•
Remove material connection 98590 completely
•
Pull out the insert 98509 from the spray gun via the paint nozzle and remove paint
nozzle
•
Plug in insert 98509 aligned with drilling for the material connection
•
Seal material connection with Loctite 276 and install, required locking torque
30 Nm
