121
EN
Operating instructions SATAminijet 1000 K/H RP/HVLP
Operating instructions SATAminijet 1000 K/H RP/HVLP
Malfunction
Cause
Corrective Action
Round/flat spray con
-
trol cannot be regu-
lated
Control has been
turned too much in
counterclockwise di-
rection; spindle has
loosened inside the
spray gun thread
Remove the control
with universal spanner;
rectify or replace com-
pletely, chapter 9.6
Spray gun does not
shut-off air
Clogged air piston seat
or worn air piston
Clean air piston seat
and/or replace air pis-
ton, air piston packing,
chapter 9.4
Corrosion on air cap
thread, inside material
passages (cup con-
nection) or on spray
gun body
Cleaning solution
(water-based) remains
inside/on the spray
gun for too long.
Cleaning, observe
chapter 8
, get a re-
placement spray gun
body
Unsuitable cleaning
media
Material leaks from
behind the paint nee-
dle seal
Defective or missing
paint needle seal
Replace / insert paint
needle seal, chapter
9.3
Clogged or damaged
paint needle.
Replace nozzle set,
chapter 9.1; replace
paint needle seal, if
necessary, chapter 9.3
Spray gun leaks from
the fluid tip ("fluid tip
aperture")
Contamination be-
tween paint needle tip
and fluid tip
Clean fluid tip and
paint needle, observe
chapter 8
Damaged nozzle set
Replace nozzle set,
chapter 9.1
11. Disposal
Recycle the completely empty spray gun. To protect the environment, bat-
teries and residual paint have to be disposed in an appropriate way and
separately from the spray gun. Please observe local legislation!
