Chapter 5 Setting Up the ETC II
Changing the Password and Security
ETC II Network Communicator
33
Chapter 5
Setting Up the ETC II
You can configure your ETC II via the Terminal program connected to the
device through the COM3 service port, via the Telnet, or via PAS. See
Connecting to the ETC II
for information on establishing a connection with
your device using different communication options.
Changing the Password and Security
Using HyperTerminal or Telnet
To change your password or a security option:
Type
password
and press Enter. The following prompt appears:
> password
New Password [0-99999999]:
To change the password, type your new password (up to 8 digits) and press
Enter, then repeat your new password when prompted and press Enter. To
leave the password unchanged, just press Enter.
New Password [0-99999999]: ********
Repeat Password [0-99999999]: ********
Type
y
to enable or
n
to disable password checking, and then press Enter.
To leave the current setting unchanged, just press Enter.
Comm/Network Protection Enabled [y/n]: N
New: Y
Using PAS
To change the password, check the On-line button on the PAS
toolbar, select Administration from the Monitor menu, and then
select Change Password.
To change the password:
1.
Type in a new 8-digit password.
2.
Repeat the password in the Confirm box.
3.
Check the “Enable network protection” box to enable
password checking.
4.
Click Send.
Changing Time and Date
Using HyperTerminal or Telnet
To view or change time or date in the ETC II, type
time
or
date,
and then
press Enter. To change the time or date, type the new setting after the
prompt and press Enter. To leave the time unchanged, just press Enter.
>time
