SATEL ASD-150
3
15. Press and hold down the test / reset button (designated with the letter A in Figure 2). Alarm should be
triggered after a few seconds.
5. Battery replacement
The used batteries must not be discarded, but should be disposed of in accordance with the
existing rules for environment protection.
The detector power supply battery (CR123A 3 V) ensures operation for about 2 years. If the detector is used as
part of the ABAX system, low battery information (voltage drop down to 2.75 V) is sent to the ACU-120 / ACU-
270 controller / INTEGRA 128-WRL control panel. If the detector is working in the stand-alone mode, the
information is presented optically and acoustically – 3 short LED flashes and 3 short sounds every 30 seconds.
1. If the detector is used in the ABAX system, start the service mode in the control panel.
2. Remove the screw fastening the cover (Fig. 1).
3. Turn the cover counter-clockwise (Fig. 2) and remove it (Fig. 3).
