4 ASP-200
SATEL
Power supply
The siren is powered from a 3.6 V lithium thionyl chloride battery. It is a high-current battery,
characterized by high capacity. The battery is offered by SATEL.
The siren provides information about battery condition during each transmission.
If you want to replace the low battery with a fresh one, follow the procedure described
in the “Battery replacement” section (p. 5).
Enclosure base
Explanations for Fig. 2:
mounting hole.
mounting hole for tamper protection.
spirit level.
4 Installation and start-up
Never shorten or deform the antenna.
There is a danger of battery explosion when using a different battery than
recommended by the manufacturer, or handling the battery improperly.
Be particularly careful during installation and replacement of the battery. The
manufacturer is not liable for the consequences of incorrect installation of the
battery.
The siren must be installed on the wall, high above the floor, at a hard to access location, so
as to minimize the risk of tampering. Make sure that some free space is left above the siren
(at least 2.5 cm). Otherwise, it will be impossible to replace the cover.
1. Remove the cover locking screws.
2. Lift up the enclosure cover by approx. 60º and remove it (Fig. 3).
3. Connect the battery. The leftmost LED will start flashing every second to indicate that the
battery initialization procedure has begun. Given the specific character of the battery, it
must be properly initialized to reach the required power supply parameters. When the
