SATEL ASP-205
3
when the ABAX system is running in test mode,
when the control panel is running in service mode.
The command to block/unblock the signaling is connected with starting/ending the test
mode or the service mode is sent during the polling.
Battery status control
When the battery voltage is below 2.5 V, information about low battery is sent during each
transmission.
Enclosure base
Explanations for Fig. 2:
mounting hole.
tamper mounting hole.
4. Installation and start-up
There is a danger of battery explosion when using a different battery than
recommended by the manufacturer, or handling the battery improperly.
Be particularly careful during installation and replacement of the battery. The
manufacturer is not liable for the consequences of incorrect installation of the
battery.
The used batteries must not be discarded, but should be disposed of in
accordance with the existing rules for environment protection.
Never shorten or deform the antenna.
The siren should be installed indoors, in spaces with normal air humidity. The siren must be
installed on the wall, high above the floor, at a hard to access location, so as to minimize the
risk of tampering. Make sure that some free space is left above the siren (at least 1 cm).
Otherwise, it will be impossible to replace the cover.
1. Remove the cover locking screws.
2. Lift up the enclosure cover by approx. 60º and remove it (see Fig. 3).
3. Install the battery.
