4 ASP-205
SATEL
4. Add the siren to the wireless system (see the ABAX controller manual or the
INTEGRA 128-WRL / VERSA / VERSA Plus / VERSA IP control panel installer manual).
The sticker with serial number which shall be entered when registering the siren in the
system can be found on the electronics board.
5. Replace the siren cover.
6. Fasten the siren temporarily at the place of its future installation.
7. Check the level of signal received from the siren by the ABAX controller or the
INTEGRA 128-WRL control panel. If the signal level is lower than 40%, select another
place for installation. Sometimes, it is sufficient to shift the device ten or twenty
centimeters to obtain a considerable improvement in the signal quality.
8. Remove the siren cover.
9. Remove the battery.
10. Place the enclosure base on the wall and mark the location of mounting holes (see
Fig. 2). Be sure to take into account the tamper mounting hole.
11. Drill the holes for wall plugs (screw anchors).
12. Secure the enclosure base to the wall with wall plugs (screw anchors) and screws.
Remember about the tamper mounting hole. The wall plugs (screw anchors) and screws
delivered with the siren are intended for brick, concrete and similar mounting surfaces.
For other surfaces (e.g. drywall, wood, styrofoam), use other wall plugs (screw anchors),
as required.
13. Install the battery.
14. Replace the siren cover and fasten it with screws.
15. Configure the siren (e.g. define the way of signaling and maximum duration of signaling).
For detailed information on how to configure the siren, refer to the controller / control
panel manual.
SATEL sp. z o.o. • ul. Budowlanych 66 • 80-298 Gda
ń
sk • POLAND
tel. +48 58 320 94 00
www.satel.eu
