GFU27 User Guide
Version
3.0
14
Additional setup
Error correction
OFF
ON/OFF
Error check
OFF
ON/OFF
Repeater OFF
ON/OFF
SL-commands ON
ON/OFF
Priority
TX
RX/TX
FullCR16 Check
OFF
ON/OFF
Routing
OFF ON/OFF
Tests
OFF ON/OFF
*) Tested with Pacific Crest PDL products.
3.2
Configuration
The configuration of GFU27 modems is made by using the SATEL Configuration Manager or in
programming mode with a terminal program.
Please use GEV171 programming cable to connect the GFU27 modem to the serial interface of
the PC.
SATEL Configuration Manager software and user guide are available on the CD for GFU27
radio modem or from www.satel.com
3.3
Programming Mode
The settings of GFU27 are fully configurable in
Programming Mode
by using a suitable terminal
program. The most recommendable set-up is GEV171 programming cable, a power supply and
the
SaTerm
terminal program. GEV171 cable contains a Prog mode switch to enable easy
shifting into the
Programming Mode
.
The radio modem will shift into the
Programming Mode
by setting the Lemo connector pin 7 to
+12 V. When using the GEV171 cable this can be accomplished by setting the Prog mode
switch to ON position.
In the
Programming Mode
, the radio modem uses settings 9600 bps, N, 8,1 (data transfer
speed 9600 bps, no parity, 8 data bits and 1 stop bit). For more detailed instructions for
changing each setting, see SATELLINE-3AS product family user guide.
3.3.1
Changing the settings
o
Connect cables (GEV171 cable to PC COM-port and to a power supply).
o
Switch on the PC and start
SaTerm
program (or other terminal program).
