GFU27 User Guide
Version
3.0
15
o
Open a terminal window and then choose ”Pr”.
o
Connect Prog mode switch ON. The radio modem shifts now into the
Programming
Mode
. The screen should look similar to the one shown in the picture below.
o
Make desired changes to the settings.
o
Save changes by pressing ”E” in the main menu. If you don’t want to save changes, press
”Q”.
o
Set Prog mode switch to OFF position, the radio modem should now return to the
Data
Transfer Mode
.
***** SATEL 3AS *****
SW Version x.yz
--------------------------------------------------------------------------------
Current settings
----------------
1) Radio frequency 438.0000 MHz ( CF 438.0000 MHz, spacing 25 kHz )
2) Radio settings Tx power level 1000 mW / Signal threshold -112 dBm /
TX start delay 0 ms / Diversity mode OFF
3) Addressing RX address OFF / TX address OFF /
RX address to RS port OFF / TX address autoswitch OFF
4) Serial port 1 ON / 19200 bit/s / 8 bit data / None parity / 1 stop bit
5) Serial port 2 OFF / 19200 bit/s / 8 bit data / None parity / 1 stop bit (RS-485)
6) Handshaking CTS Clear to send / CD Data on channel / RTS Flow Control
7) Additional setup Error correction OFF / Error check OFF / Repeater OFF /
SL-commands ON / Priority TX
8) Routing OFF
9) Tests OFF
A) Restore factory settings
E) EXIT and save settings
Q) QUIT without saving
Enter selection >
