SATEL
INT-SK
9
A sequence of 7 beeps of diminishing duration, repeated every few seconds
–
countdown of auto-arming delay.
2 short beeps every second
– countdown of entry delay.
Continuous beep
– alarm.
Long beep every 2 seconds
– alarm memory.
Long beep every second
– fire alarm.
Short beep every 2 seconds
– fire alarm memory.
Very short beeps
– door open too long.
4.3 Code
Most of the functions are available after entering the code. By factory default, the following
codes are programmed in the control panel:
service code: 12345
object 1 master user (administrator) code: 1111
The factory default codes should be changed before you start using your alarm
system
Do not make your code available to other people.
4.4 Available functions
Availability of the functions depends on:
•
type and rights of the user,
•
keypad settings,
•
partition state.
If you use the code to arm / disarm the partition and the
and
LEDs start
flashing alternately, this will mean that the keypad is waiting for the code of the other
user (arming / disarming using 2 codes).
4.4.1 [Code]
Enter the code and press
to:
•
disarm the partition,
•
clear alarm,
•
gain access (turn on the expander relay output),
•
toggle the state of “25. BI switch” type outputs,
•
turn on the “24. MONO switch” type outputs,
•
confirm the guard round,
•
temporary block the partition.
You can start two or more functions at the same time (e.g. disarming, alarm clearing and
gaining access).
4.4.2 [Code]
Enter the code and press
to:
•
start the procedure of partition arming / arm the partition,
•
disarm the partition,
