32
Installer Manual
SATEL
expander). The changes in numeration will only be valid until you start the expander
identification function again.
7. Replacing the battery on control panel mainboard
It is recommended that the status of clock and RAM memory backup battery be checked e.g.
during periodical inspections, at least every 5 years. The battery life depends on:
•
temperature,
•
humidity,
•
time during which the control panel power supply is off,
•
battery self-discharge.
If the battery is low, it must be replaced with a new one of the same type (CR1220).
Be particularly careful during replacement of the battery. The manufacturer is
not liable for the consequences of incorrect installation of the battery.
Replace the battery when the control panel power supply (main or backup) is on.
If you remove the battery when the control panel power supply is off, the data
stored in the RAM memory (event log, user data, clock settings) will be lost.
8. Specifications
8.1 Control panel
Supply voltage ................................................................................... 18 V AC ±15%, 50-60 Hz
Recommended transformer ............................................................................................. 40 VA
Standby current consumption from AC mains ................................................................ 120 mA
Maximum current consumption from AC mains ............................................................. 300 mA
Standby current consumption from battery .................................................................... 280 mA
Maximum current consumption from battery .................................................................. 600 mA
Battery failure voltage threshold ............................................................................... 11 V ±10%
Battery cut-off voltage ........................................................................................... 10.5 V ±10%
Battery charging current .......................................................................................... 400/800 mA
Power supply output current ................................................................................................ 2 A
Power supply output voltage range .................................................................... 10.5…14 V DC
Current-carrying capacity, high-current programmable outputs ................................. 2 A ±10%
Current-carrying capacity, low-current programmable outputs .........................................50 mA
Current-carrying capacity, +KPD output .................................................................. 0.5 A ±10%
Current-carrying capacity, +EX output .................................................................... 0.5 A ±10%
Current-carrying capacity, AUX output .................................................................... 0.5 A ±10%
ABAX system operating frequency band ............................................. 868.0 MHz ÷ 868.6 MHz
Radio communication range (in open area) ............................................................ up to 500 m
Number of supported wireless devices .................................................................................. 48
Number of supported APT-200 / APT-100 keyfobs .............................................................. 248
Hardwired programmable zones .............................................................................................. 8
Maximum number of programmable zones .......................................................................... 128
