background image

KNX-SA41 

• KNX-SA24 

SATEL 

4.2  Maximum output loads for lighting 

Incandescent lamps ....................................................................................................... 3680 W 

HV 230V halogen lamps ................................................................................................ 3680 W 

LV halogen lamps: 

 

inductive transformer ....................................................................................... 2000 VA 

 

electronic transformer ........................................................................................ 2500 W 

Fluorescent lamps: 

 

non compensated .............................................................................................. 3680 W 

 

parallel compensated .......................................................................... 2500 W, 200 

µF 

 

series compensated ............................................................................ 3680 W, 200 

µF 

Compact fluorescent lamp (CFL): 

 

non compensated .............................................................................................. 3680 W 

 

parallel compensated .......................................................................... 2500 W, 200 

µF 

High-pressure mercury lamps: 

 

non compensated .............................................................................................. 3680 W 

 

parallel compensated .......................................................................... 3680 W, 200 

µF 

Exceeding  the  limit  values  of  the  module  working  parameters  may  damage  the 
module and pose hazard to human health or life. 

 

Summary of Contents for KNX-SA41









Reviews: