SATELLINE-EASy Pro 35W
User Guide v.1.4
57
9.2.13
Activating tests
Tests can be activated by selecting main menu selection ”9”. Tests are activated by setting the
status of the desired test to ”ON” and will remain active until the value of the selection in the
menu is returned to the value ”OFF”.
9.2.14
Restoring factory settings
The settings that the modem was delivered from the factory are called “factory settings”.
Selecting main menu selection “A” can restore factory settings.
Enter selection >A
Restore factory settings
------------------------
Do you want to restore factory settings? (Y/N)>
Restoring is confirmed by pressing ”Y” (Y=YES) or cancelled by pressing ”N” (N=NO). Also the
pressing of ”ESC” button at any point in the procedure will return the display to the previous (next
higher) menu level without restoring factory settings.
9.2.15
Info
The Info display shows all the functionality of the modem.
Device = Modem type. Serial number= yyyymmddxxx. FW version= xx.xx.xx.xx.
Board version= Main board version SPLxxxxn. Module version= Voltage range, Port 2
interface. Tuning range= Total tuning range.
Enter selection >b
Info menu
---------------------------------------
Device:
SATELLINE EASy-35W
Serial number:
xxxxxxxxxxxxx
FW version:
06.18.x.xx
Board version:
SEPT
Module version:
Voltage: 9-16V
Tuning range:
403.00000 - 473.00000 MHz
Press any key to return >
Enter selection >9
Tests setup
-----------
1) Short block test OFF
2) Long block test OFF
NOTE! Message Routing and FCS mode must be disabled in prior to set ON the Test mode.
