background image

4 SPW-250 

SATEL 

 

133

mm

87 mm

37 mm

 

Fig. 4. Indoor siren dimensions. 

 
 

Always use the CR123A 3V lithium batteries. 
Service representative should periodically check the battery status within the 
scope of maintenance work. 
Be particularly careful when replacing the battery. If inappropriately done, 
replacement of the battery may lead to a risk of explosion. The Manufacturer 
bears no responsibility for any consequences of incorrect replacement of the 
battery. 
The used batteries must not be discarded, but should be disposed of in 
accordance with the existing rules for environment protection. 

 
 
 

The latest EC declaration of conformity and product approval certificates can 

be downloaded from 

www.satel.pl

 

 

 
 
 

SATEL sp. z o.o. 

ul. Schuberta 79 

80-172 Gda

ń

sk 

POLAND 

tel. + 48 58 320 94 00 

info@satel.pl 

www.satel.eu 

 

Summary of Contents for SPW-250

Page 1: ... back up power supply Alarm by main power failure Tamper protection against opening and removing from the mounting surface Housing made of PC LEXAN high impact polycarbonate featuring a very high mechanical strength Fig 1 View of the indoor siren Explanations for Fig 1 1 housing base 2 screws securing the siren to its mounting surface 3 piezoelectric transducer 4 tamper contact 5 electronics board...

Page 2: ...les to piezoelectric transducer 5 cables to tamper contact 3 Description of Operation The indoor siren requires power supply from a 12 V 15 DC voltage source The acoustic alarm will be triggered on loss of the control signal fed to the terminal D depending on the configuration common ground or 12 V DC voltage and continues until the signal is restored Additionally the signaling will be set off if ...

Page 3: ... 250 12V TMP TMP D COM CONTROL PANEL Fig 3 Way of connecting the siren to the alarm control panel OUTx control panel output with power supply function OUTy control panel output for signaling control Zx control panel zone programmed as 24h tamper Note Reversed polarity must be programmed for SPW 250 siren control outputs in the SATEL made control panels 5 Specifications Power supply voltage 12 V DC...

Page 4: ...ement of the battery may lead to a risk of explosion The Manufacturer bears no responsibility for any consequences of incorrect replacement of the battery The used batteries must not be discarded but should be disposed of in accordance with the existing rules for environment protection The latest EC declaration of conformity and product approval certificates can be downloaded from www satel pl SAT...

Reviews: