SatX/SE300—
Front Panel Operation
Proprietary and Confidential
39
4.2.4.1
Management
On this submenu all relevant parameters regarding the management scheme of the unit can be viewed,
starting with IP address and including SNMP and masking alarms.
1.
Use the
◄
►
arrow keys to select the item to configure.
2.
Click
OK
to continue.
4.2.4.1.1
IP
This submenu shows the management port IP settings.
1.
Click
OK
to review or view settings.
2.
Click
ESC
to continue.
4.2.4.1.1.1
IP Address
This field shows the device management port IP address. Changing the IP address is done via the
Network-Config > Interfaces
menu.
4.2.4.1.1.2
Subnet Mask
This field shows the device management port IP net mask. Changing the IP net mask is done via the
Network-Config > Interfaces
menu.
4.2.4.1.1.3
Default Gateway
This field shows the device default gateway, in the event that a gateway is configured in the
Network-
Configuration >Routes
for address 0.0.0.0. If this is not the case, the displayed value will be 0.0.0.0.
4.2.4.1.2
Rate-Limiter
This submenu is used to configure the management traffic rate limit.
4.2.4.1.2.1
Rate-Limit
This field is used to set the management traffic rate limit in Kbit/sec. The value 0 indicates an unlimited
traffic rate limit.
4.2.4.1.3
SNMP
This submenu item is used to configure all SNMP related parameters.
4.2.4.1.3.1
SNMP Version
Defines the SNMP version with which the unit will comply.
1.
Click
OK
to change the version.
2.
Browse through the list using the
▲
▼
arrow keys.
3.
Possible values:
o
V1&V2: only V1 and V2 messages are supported.
o
V3: only V3 messages are supported.
4.
Select an SNMP version by clicking
OK
.
4.2.4.1.3.2
Read Only Community
Defines the SNMP community string for read only access.
