SatX/SE300—
Front Panel Operation
Proprietary and Confidential
61
4.2.7.1.1
Mode
Select the technology for the current session on this submenu.
1.
Use the
◄
►
arrow keys to select the item to configure.
2.
Possible values: DVB-S2, SATX and SATEX.
3.
Click
OK
to accept the value.
4.2.7.1.2
LNB-LO-Freq
View the LNB Local Oscillator frequency in this submenu. This field is only informative in nature and
saves the user the calculation for IF or L-Band frequency.
1.
Enter the frequency using the numeric keypad.
2.
Possible values: 0 to 40000MHz.
3.
Click
OK
to accept.
4.2.7.1.3
RF-Freq
Select the IF or L-Band frequency of the demodulator on this submenu.
1.
Enter the frequency using the numeric keypad in this submenu.
2.
Possible values:
o
IF: 50-90MHz and 100-180MHz.
o
L-Band: 950 – 2150MHz.
3.
Click
OK
to accept.
If the LNB-LO-Freq is used, the RF frequency shown will be the sum of the two values.
4.2.7.1.4
Dual-Channel-Mode
Select if the dual channel per carrier option will be enabled.
The dual channels support, for example, the following options:
o
IP data from Gig-E + video stream from ASI.
o
IP data from Gig-E + internal PRBS generator.
o
Internal PRBS gen video stream from ASI.
o
Video stream-1 from ASI-A video stream-2 from ASI-B
1.
Navigate through the list using the
▲
▼
arrow keys.
2.
Possible values:
o
Single:
Single channel is used
o
Dual:
Dual channel is used
3.
Select an item by clicking the
OK
key.
4.2.7.1.5
Symbol-Rate
Set the demodulator’s symbol rate, in units of MSPS with 1SPS resolution.
1.
Enter the rate using the numeric keypad.
2.
Possible values: SATX – 0.05 to 80Mbps, SE300 – 0.05 to 36MSPS.
