Ⅱ
- 4. Setting Management Numbers
Press the POWER and MAX / MIN keys simultaneously while the
main unit is on to set the management number.
• Example of using management numbers :
--- Person in charge (00 for Mr. Sato)
--- Object measured
(99 for heat insulating box in laboratory)
Note : Management numbers can be used in auto storage mode only.
Any two numbers between 00 and 99 can be set.
Caution!
When entering each setting mode, be sure to press the POWER key
and the other necessary key simultaneously. If the POWER key is
pressed first, the unit will be turned off.
Ⅱ
- 5. Manual Storage Mode
Press the REC / PRINT key while the main unit is on to start recording
the currently measured value. When the REC / PRINT key is pressed,
the file number and the
"
REC" are displayed on the sub 7-segment
display for approximately 0.5 second. If the total number of files
exceeds 180, pressing the REC / PRINT key displays "FULL" on the
sub 7-segment display and warning buzzer (beep) sounds. Subsequent
measured values cannot be stored.
Note : Even if the power is turned off during data storage processing,
the data will be retained. When the power is turned on again, the
operation will continue from the previously stored data. When
you do not need the stored data, be sure to clear the stored data
from the memory by pressing the POWER and SET / CLEAR
keys simultaneously and then also press the SET / CLEAR key
alone. These also apply to auto storage mode.
•
Calling Stored Data
In case the stored data is present in the unit, press the TIME key
for at least one second to display the stored temperature values
on the main 7-segment display and the file numbers on the sub
7-segment display. The temperature values and file numbers are
displayed in chronological order starting with the first file. Hold
down the TIME key to advance the temperature values and file
numbers rapidly.
Press the SET / CLEAR key to switch back to normal measurement
mode. To check the stored data again, repeat the above procedure.
Ⅱ
-6. Auto Storage Mode
Press the REC / PRINT and MAX / MIN keys simultaneously to start
recording measured values while the main unit is on. When recording
starts, "REC" is lit and the file number "F xx" and the sampling data
count "d xx" are alternately displayed on the sub 7-segment.
If the total file number exceeds 120, pressing the REC / PRINT key
displays "FULL" and warning buzzer (beep) sounds. Subsequent
measured values cannot be stored.
•
Calling Stored Data
In case the stored data is present in the unit, pressing the TIME
key for at least one second displays the measured temperature
value, maximum value, and minimum value respectively in this
order on the main 7-segment display. At the same time, the relative
measurement time is displayed on the sub 7-segment display. The
measured temperature values and measurement times are displayed
in chronological order starting with the first file.
Holding down the TIME key can fast-forward the measured
temperature value, maximum value, minimum value and the
measurement time.
Press the SET / CLEAR key to switch back to normal measurement
mode. To check the stored data again, repeat the above procedure.
Note : If you want to quit auto storage mode to check the stored data in
17
18
Summary of Contents for SK-1260
Page 16: ......