MDR-4330AT USER MANUAL
12
83-00-001-DOC
MDR-4330AT with
red
&
green
LED’s illuminated
The
red LED
will illuminate again after approximately 1 minute
indicating that the unit is in an operational state
Once the unit is in an operational state the
red LED
will remain permanently illuminated
The LED’s are controlled by the MDR-4330AT Reader software
Step 3. Test the Reader with a known working RFID tag. The green LED will light
when an RFID tag is successfully read.
3.3.1 Connecting a Reader to a Computer using USB
Connect the MDR-4330AT Reader to a host computer using a USB data communication
cable by plugging the USB cable into the MDR-4330AT “ USB Device” port and the host
computer USB port. Switch the reader on. It can take up to 4 minutes for windows to load the
USB drivers for the reader on some computers. Once the USB driver has loaded the reader
will be listed under Network adapters as a “Linux USB Ethernet/RNDIS Gadget”.
Windows operating systems may occasionally load the incorrect USB drivers for the reader. If
you experience an issue with the incorrect driver loading refer to Magellan Technology
Technical Bulletin 0009 (TB-0009), Available from Sato Vicinity or your local reseller.