OS-214EX / OS-200
User Manual
51
5.4 Ribbon Problems
The ribbon is out
Load a new ribbon roll.
The ribbon is broken
Check the print darkness and adjust it if it is too high, and take the following
steps to fix the broken ribbon:
1.
Unload the ribbon supply roll and take-up roll from the printer.
2.
Pull the ribbon from the supply roll so it overlaps the broken end of the take-up
roll.
3.
Tape the overlapped parts together.
4.
Reload both rolls into the printer.
The ribbon is “printed out” with the media
The ribbon is not loaded correctly. See the “Load Ribbon” section to reload the
ribbon.
The printhead temperature is too high. Reload the ribbon and print a
configuration label to check the settings (see the “Self Test mode” section). If
the print darkness is very high, adjust it in printer preference, or reset your
printer (see the “Restore Your Printer” section).
The ribbon is wrinkled
1.
Make sure the ribbon is loaded correctly.
2.
Rotate the
Take-Up
Wheel
to straighten the ribbon.
Summary of Contents for ARGOX OS-200 Series
Page 29: ...OS 214EX OS 200 User Manual 23...
