3:
J
OB
S
ETUP
pn 9386295-01
33
3. J
OB
S
ETUP
This chapter describes how to set up a new job and how to edit a current job on the CS-
9018.
Before proceeding, make sure you have the proper slitter cartridge assembly and have
made the necessary adjustments for the job. Refer to section 2.11.2.3 “Changing the Slitter
Cartridge” for instructions on how to change this assembly, if necessary.
Chapter 6.2 contains a Job Setup Sheet that can be photocopied and used to document all
of your job settings. This will be a useful tool in the event of a loss of machine memory.
3.1. E
NTERING THE
O
PERATOR
S
ETUP
S
CREENS
•
Press
the
key.
•
Enter Password 12345 for Operator Mode.
•
Press
again to set the password.
•
Press and hold
, the current job number will appear:
<Edit Job.> 01 (JOB NAME)
>>Job Num.: 01
•
Release
the
key.
•
Press
to scroll through the available jobs.
3.2. E
DIT A
C
URRENT
J
OB
With the exception of Job 90, which is reserved for service tests, any job can be edited.
•
Continue to scroll
until the job to be changed is displayed.
•
Scroll through the menu for that job by pressing the
key until the setting to be
changed is displayed.
Note: Scroll in reverse by pressing the
key.
For information on how to change settings see Chapter 3.3 “PROGRAM A NEW JOB”.
Summary of Contents for CS-9018
