3:
J
OB
S
ETUP
pn 9386295-01
35
3.3.3.
Strip delay, 1=5msec
Recommended starting point: 25
This is used only when removing the perf between forms. It provides a small amount of
time for the chips to fall after being cut by the oscillating blade and before the next row of
tickets are advanced to the oscillating knife. Without this delay the chips will be carried to
the stacker and will be mixed in with the tickets.
This delay will only function when a cut length of less then ½ inch (00+48 on the display) is
programmed. Generally a chip width of 1/8” will give the best results.
•
Press
the
key to go to the next parameter.
3.3.4.
Paper load offset
Use this setting when using the chip removal feature. When paper is first loaded it will
advance past the oscillating knife ½ the length off the chip being removed. The knife will
then make its first cut (1/2 of the normal chip length).
•
Set to one half of the chip dimension (cut length of the chip divided by 2)
Example:
If you plan to remove
1/8
” on either side of the perf or ¼” total, the “Cut
Length” for the chip should be set to “00+24” and the “Paper load offset”
should be set to
1/8
” or “00+12”. See the example following “Cut Length”.
Note: All lengths are set in 96ths of an inch. Example:
1/8
” = 00+12
¼” = 00+24
½” = 00+48
1½” = 01+48
•
Press
the
key to go to the next step.
Summary of Contents for CS-9018
