CS-9018
O
PERATOR
’
S
G
UIDE
36
CS-9018 Operator’s Guide
3.3.5.
Cut Length 01, “+/96: 03+24
Refer to the “INCHES FRACTION CONVERSION TABLE” at the end of this section.
•
Enter ticket length in inches, see Chapter 3.5 “TAG LENGTH REFERENCE
TABLE” and 3.6 “INCHES FRACTION CONVERSION TABLE”.
•
Press “+”, enter fractional remainder in 1/96” e.g. 3.25” is “03” “+” “24”.
•
Forms must be removed and reloaded after a new setting is selected.
•
Press
the
key to go to the next step.
3.3.6.
Cut Length 02, “+/96: 03+24
If only one length ticket is required Cut Length 02 should be ignored. If it is desirable to
remove the perforation between forms (chip removal) then it will be necessary to program
additional Cut Lengths. The Cut Length for the chip removal must be the last length
programmed. An additional Cut Length must be programmed for each ticket between the
perforations.
Example:
You have a 10” form and wish to have 1/8” removed on either side of the perforation. All
tickets are to be 3-1/4” (due to the perf removal). The first three cut lengths would be
programmed “03+24”
Cut Length 04 (the chip) would be ¼ of 96 or 24. Program this in the format “00+24”
Remember, all measurements are in 96 = 1”.
Program in the following:
Cut Length 01 03+24
Cut Length 02 03+24
Cut Length 03 03+24
Cut Length 04 00+24
NOTE: If used, chip removal length must always be the last cut length
programmed. See the example on the next page. See also, Chapter
3.3.3 “Strip delay” and 3.3.4 “Paper load offset”.
•
Press
the
key to go to the next step.
Summary of Contents for CS-9018
