CS-9018
O
PERATOR
’
S
G
UIDE
46
CS-9018 Operator’s Guide
To Re-install the Oscillating Blade Cartridge:
C
AUTION
!
T
O PREVENT DAMAGE TO THE OSCILLATING BLADE CARTRIDGE
,
USE GREAT
CARE WHEN RE
-
INSTALLING
.
D
O NOT FORCE THE CARTRIDGE INTO PLACE
.
SET IT GENTLY INTO POSITION
.
1.
Place the blade cartridge back in the CS-9018. Ensure it is setting flat in
the side frame cut outs (the top of the cartridge should be flush with the top
of the side frame on both sides).
2.
Remove the blade cartridge removal handles
3.
Re-install the two securing screws.
4.
Adjust the ticket length to the correct length.
4.1.2. Tickets
will
jam at the hood if:
•
The ticket length adjustment is not set properly.
•
The stacker height is not adjusted properly.
•
The tickets are not centered across the vacuum belt when they feed into the hood.
•
The rear deflector plate is not set correctly.
•
The vacuum level is not set correctly.
•
The vacuum transport belt is not tracking properly.
When tickets jam in the hood, the stacker sensor will detect the problem and stop the
motors. An error message “
STACKER JAM
” will alert you to the problem.
To correct the jam:
•
Raise the hood and remove any tickets that are jammed under the hood, and all
that remain on the vacuum transport belt.
•
Press
to clear the error.
•
Close the hood tightly.
Check to make sure:
•
There is no obvious obstruction along the paper path.
•
The paper feeding into the CS-9018 is aligned properly.
•
The vertical perforations are aligned correctly and are cutting on the perf.
•
The paper is taut between the two tractors.
•
The edge of the stock is not wrinkled, torn, or otherwise damaged.
•
The stacker and transport are aligned correctly.
•
The stacker height is adjusted so that there is approximately 1/16” (1.6 mm)
between the top of the tickets and the roller running across the hood assembly.
•
The tickets are centered across the vacuum belt when they feed into the hood.
•
The vacuum level is set correctly.
•
Press
twice to restart processing.
If the blockage recurs, contact your Supervisor or Service Engineer.
Summary of Contents for CS-9018
