5:
C
ARING FOR THE
CS-9018
pn 9386295-01
51
5. C
ARING FOR THE
CS-9018
This chapter details the routine maintenance procedures required to maintain the CS-9018
cutter stacker.
Chapter 3 discusses other procedures: specifically, those involved with normal job setup. If
you require information that is not covered here, first refer to Chapter 3.
CAUTION:
I
F YOU ARE UNFAMILIAR WITH ANY PROCEDURES OR REQUIRE
MAINTENANCE BEYOND THE SCOPE OF THESE PROCEDURES
,
CONTACT
YOUR SUPERVISOR FOR INSTRUCTION
.
5.1. R
OUTINE
M
AINTENANCE
The CS-9018 requires a certain amount of routine maintenance to ensure a trouble-free
operation.
WARNING:
A
LWAYS SWITCH THE MAIN POWER SWITCH
OFF
AND UNPLUG THE MAIN
POWER TO THE CUTTER STACKER BEFORE PERFORMING ROUTINE
MAINTENANCE
!
Daily
1) Clean any paper dust from the unit using a portable vacuum cleaner. Make sure to
check the hood and transport areas.
2) Remove the waste (pin-feed trim) from behind the unit daily or as required to keep
the area clear.
Weekly
1) Clean the vacuum air filter
2) 2 drops of a lightweight machine oil placed on the tractor bearings as shown. Run
machine for a couple of minutes to run in.
3) Place 1 drop of a lightweight machine oil on each end of the oscillating blade and
wipe across blade. Cycle blade by hand a few times.
PLACE 2 DROPS OF OIL ON SHAFT AT THIS LOCATION
Summary of Contents for CS-9018
