21
1
2
3-Inch Paper-core Rewinding
Attach the provided 3-inch core adaptor to the rewinding shaft.
At this time, align the locking screws to the guides (narrow-
width guide and deep-groove guide) of the rewinding shaft.
Left
Screw holes
Right
A d j u s t t h e c o r e p o s i t i o n
according to the label width,
and then lock it by tightening
the screws.
Number of cores to be used
s h o u l d b e d e t e r m i n e d
referring to the following
standard.
Phillips screwdriver is
necessary.
Teeth
(for fixing the paper tube)
Adjust the core teeth direction
so that it will be the same as
the Rewinding direction.
Face in Rewinding : Left direction
Face out
Rewinding :
Right
direction
Label width of below 65mm : 1 piece
Label width of 65mm
: 2 pieces
Guide
(narrow-width guide,
deep-groove guide)
and above
22
3
4
Insert the paper tube, then fix
the label with an adhesive
tape, etc.
Lastly, insert the label guide.
Label setting is completed.
!
CAUTION
The Status LED on the control panel blinks in green (idling state).
The power of the rewinder is turned OFF.
Label setting may be performed only in either of the following states:
Summary of Contents for RWG500
Page 15: ...MEMO MEMO...
Page 16: ...MEMO First edition 15 Oct 2004 DCS Labeling Worldwide...
