SATO RWG500, Quick Manual

23

1 

1 

.

After the label has been set, rewinding of the label can be performed.
The followings are the rewinding procedures.

Turn on the power switch on the side of the rewinder.
After for a while, the status LED on the control panel will start 

blinking in green

. At this time, the rewinder is in 

idling status

.

Press down and hold

 the START/STOP switch on the 

control panel. The rewinding shaft starts rotating, and the 
tension arm rises and then stops automatically. When the 
LED is 

lit in green continuously

, which shows the 

rewinder 

is now in rewinding operation

, release the switch.

Turn on the power of the rewinder.

Take up the slack in the label.

2

If the switch is released before the slack is taken up, the 
rewinder stops automatically and the status LED 

continues

blinking in green (I.e., idling status)

. In this status, the 

rewinder will not perform label rewinding operation.
Make sure to press down and hold the switch until the LED is

lit in green continuously

.

Basic Usage of the Rewinder

24

5 

5 

After removing the label on the printer side, then remove 
the label rewound with this rewinder.
The rewound label can be removed easily because the 
tension arm has been down. 

Remove the rewound label.

When the rewinding is completed, press the START/STOP 
switch on the control panel.
The tension arm comes down and stops automatically.
The status LED 

blinks in green

 and the rewinder returns 

to the 

idling status

.

Operate the printer and start issuing the label.
Slack in the label and issuing speed are detected automatically 
before performing rewinding.

Start automatic rewinding.

When the rewinding is completed.

3

4