113
S84-ex/S86-ex Service Manual
7.1 Conditions for Use with Support Structure/
Applicator
When designing the specifications for using this printer with an applicator, there are some parameters
needed to be considered, such as the media unwinder and liner rewinder supplied by the applicator and
the operating environment.
However, the operating conditions may vary depending on the actual situation.
Adjust these conditions when necessary.
7.1.1
Media Forward Feed Force
The maximum amount of forward feed force of the print engine can be used for the printer applicator
label supply.
7.1.2
Media Allowable Load
The constant force pulling back the media to the supply side must be as follows:
Criteria of allowable load
• The print position difference between the media load and no media load should be within ±1.5 mm.
• Should not include the change due to the ribbon diameter.
• Should not include the change due to temperature and humidity.
• Should not include the shock.
• The print mode is DISPENSER with the RIBBON SAVER function disabled.
7
Appendix
Media Width
Liner Width
Maximum Media Forward Feed Force
Less than 25 mm
Less than 28 mm
1,000 g
From 25 to 108 mm
From 29 to 111 mm
Formula: 12 g x media width in mm + 700 g
108 mm and above
111 mm and above
2,000 g
Media Width
Liner Width
Media Allowable Load
From 10 to 15 mm
From 13 to 18 mm
Less than 250 g
From 15 to 25 mm
From 18 to 28 mm
Less than 400 g
From 25 to 45 mm
From 28 to 48 mm
Less than 900 g
From 45 to 80 mm
From 48 to 83 mm
Less than 1,200 g
80 mm and above
80 mm and above
Less than 1,400 g
Summary of Contents for S84 ex
Page 1: ...Service Manual For printer model ...
Page 6: ...Table of Contents 4 S84 ex S86 ex Service Manual This page is intentionally left blank ...
Page 104: ...5 Replacement 102 S84 ex S86 ex Service Manual This page is intentionally left blank ...
Page 123: ...7 Appendix 121 S84 ex S86 ex Service Manual This page is intentionally left blank ...
