6
without needing a dust bag. The sucked
up dirt is forced into the dust container
by force of the air jet instead. The air is
cleaned by a washable permanent filter
in the dust container, motor protection
filter and an exhaust air filter (HEPA
filter).
Caution!
Never vacuum clean without a filter or
with a damaged filter. The dust that is
sucked up would force its way into the
device and damage the motor.
Clean dust / dirt in the dust container
by an entirely new method - it’s simple,
clean and so easy.
`
Emptying dust container
You can easily see with the transparent
dust container when it must be emptied.
1. Switch off the vacuum cleaner and
disconnect the plug from the mains. To
do this always pull on the plug and not
on the cable.
2. You can pull the dust container to-
gether with the cleaning system out of
their anchoring with the aid of the carri-
er handle on the dust container. Now lift
out the dust container and carry it to
the waste bin.
3. A push button is located on the dust
container that you can use to open and
empty it automatically (bottom-down
technology).
To do this hold the dust container over
your dustbin and press on the empty
button.
4. After emptying it clean the air filter
again if necessary (see also Cleaning
the air filter below). After this rinse
out the dust container and wipe it dry.
5. After this push the air filter cleaning
system back into position in the cyclone
vacuum cleaner until it snaps into place.
Your cyclone vacuum cleaner is now
ready for use again.
6. If suction isn’t enough when dust
doesn’t reach the max, please open the
dust cup and see if there is something
twisted the cone of the filter cover.
Please clean it up on time when you find
the winding.
Cleaning the sponge filter
The sponge filter and the sponge cover
should be cleaned regularly. Cleaning is
best done when emptying the dust con-
tainer. To do this follow the instructions
in the Emptying dust container section.
1. Switch off the vacuum cleaner and
disconnect the plug from the mains. To
do this always pull on the plug and not
on the cable.
2. You can pull the dust container to-
gether with the cyclone cleaning system
out of their anchoring with the aid of the
carrier handle on the dust
container. Take hold of the carrier han-
dle on the dust container and
pull it upwards.
3. Turn the sponge cover open and take
out the sponge filter
4. Now rinse the sponge filter under
running water and allow it to dry.
5. Place the sponge filter back in the
sponge cover (or replace with a new
one) and fit it into the dust container
until it snaps into place. Your cyclone
vacuum cleaner is now ready for use
again.
Cleaning the exhaust air filter
(HEPA filter)
The exhaust air filter cleans the air a
final time before it leaves the vacuum
cleaner. You can clean the exhaust air
filter as follows:
Summary of Contents for ST-VC 7296
