Saturn TSG48-HD, Owner'S Manual

INSTALLATION (continued)

IN

ST

A

LL

AT

IO

N

 (C

on

tinued)

SET GAS PRESSURE:

Gas pressure regulator is factory set.

SET PILOT FLAME:

Remove all burner control knobs, then remove the front panel.

The pilot adjustments are near the control valve for each set of

burners.

Using a small, flat-blade screwdriver, turn the screw clockwise to

decrease the flame size, or counter-clockwise to increase the

flame size.

Adjust the pilot flame to 1/4” high. Test for operation: all sections

of the burner must light without undue delay. Drafty conditions

may require a higher flame to allow the pilot to remain lit.

Replace the front panel and all knobs before returning the unit to

service.

ADJUST BURNER FLAME:

Remove all burner control knobs, then remove the front panel.

Turn an individual burner on.

Loosen the locking screw on the shutter.

Turn the shutter to admit more or less air as required. Adjust the

air shutter until the flame is mostly blue in color.

Tighten the locking screw when finished. Replace the front panel

and all knobs before returning the unit to service.

IMPORTANT:

Adjustments must be performed

by a qualified technician only.

IMPORTANT:

This griddle is shipped from

the factory equipped for either:

natural gas and adjusted for

sea level to 2000 feet elevation;

or, propane (LP) gas and

adjusted for sea level to 5000

feet elevation.

For operation other than listed

above, contact your manufacturer

Page 8