Step 13
416955
www.sauder.com/services
Page 17
å
Carefully turn your unit over onto its front edges. Lay the BACK (I) over your unit.
å
Make equal margins along all four edges of the BACK (I). Push on opposite corners of your unit if needed to make
it "square".
å
Fasten the BACK (I) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over the SMALL UPRIGHT (D).
å
Fasten the BOTTOM SIDE SKIRTS (P) to the LEGS (K, L, M, and N). Use four SILVER 1-1/8" FLAT HEAD SCREWS (10S).
å
Push four CAM COVERS (12P) onto each HIDDEN CAM on the BOTTOM (F).
å
Center four SCREW COVERS (20P) over the head of each SCREW in the BOTTOM SIDE SKIRTS (P) and press fi rmly.
Finished sur
face
These holes must line up over
the SMALL UPRIGHT (D).
NAIL
(30 used in this step)
1N
I
P
P
N
L
K
M
SILVER 1-1/8" FLAT HEAD SCREW
(4 used in this step)
10S
Finished edge
Finished edge
(4 used)
To cover HIDDEN CAMS
To cover screws
12P
20P
(4 used)
F
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
